S60 rewrites parameters on her own while running
Posted: Fri Sep 01, 2017 5:50 am
Hi guys I'm from Italy and I'm running a S60 on a 250cc prototype bike that races in the Motostudent competition (Against a lot of Engineering universities around the world).
When we run the bike on dyno or track tests, sometimes begin to run very bad. When I open the maps, I see that some parameters has changed automatically! For example the tps columns on fuel map are all "0" or the RPM rows are strange numbers for example "4962" instead of "4500".
I refresh the old map and all turns ok.
Is there someone with the same issue?
I checked all the grounds and are ok, also Battery voltage is always 14volts.
What can cause this? Vibrations? Heat?
For sure for the next prototype I will send to Alex the ecu to check that everything is ok, we will move the ecu in a different place on the bike and pay a lot of attention for heat and vibration (like we did this year.....).
Thank you for reply
When we run the bike on dyno or track tests, sometimes begin to run very bad. When I open the maps, I see that some parameters has changed automatically! For example the tps columns on fuel map are all "0" or the RPM rows are strange numbers for example "4962" instead of "4500".
I refresh the old map and all turns ok.
Is there someone with the same issue?
I checked all the grounds and are ok, also Battery voltage is always 14volts.
What can cause this? Vibrations? Heat?
For sure for the next prototype I will send to Alex the ecu to check that everything is ok, we will move the ecu in a different place on the bike and pay a lot of attention for heat and vibration (like we did this year.....).
Thank you for reply