RCD Display Mechatromotive

Discuss issues and tuning software like DTASWin, E-Race, MegaLogViewer(DTA), etc. Also post archive versions of firmware.
Post Reply
f.slabsi
Posts: 16
Joined: Thu Mar 16, 2017 5:37 am
ECU Model: S60 Pro
Distributor: DTAfast
Firmware Version: 68.00

RCD Display Mechatromotive

Post by f.slabsi »

Hi, does anyone have any experience from the Mechatromotive RCD dashboard http://mechatromotive.com/en/termekek/rcd-display/ links with ECUmaster classic or DTA? I'm trying to connect the wiring according to the instructions but no communication with the ECU.
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: RCD Display Mechatromotive

Post by Alex DTA »

You need to turn on the generic CAN stream in the ECU.
f.slabsi
Posts: 16
Joined: Thu Mar 16, 2017 5:37 am
ECU Model: S60 Pro
Distributor: DTAfast
Firmware Version: 68.00

Re: RCD Display Mechatromotive

Post by f.slabsi »

I connected this via RS232 (Tx ecu - Rx Dashboard) that's wrong? Does it only have to be through CAN?
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: RCD Display Mechatromotive

Post by Alex DTA »

I didn't test the Rs232 output, only the CAN output, which worked fine.
You'll need to check with them if the RS232 connector can be used for data.
If it can, you'll still need to set up the header bytes in the ECU to match what the dash requires.
f.slabsi
Posts: 16
Joined: Thu Mar 16, 2017 5:37 am
ECU Model: S60 Pro
Distributor: DTAfast
Firmware Version: 68.00

Re: RCD Display Mechatromotive

Post by f.slabsi »

I have DTA attached to AUTODIGI by PHILTRONICS LTD, it works well.
Post Reply