RCD Display Mechatromotive
-
- Posts: 16
- Joined: Thu Mar 16, 2017 5:37 am
- ECU Model: S60 Pro
- Distributor: DTAfast
- Firmware Version: 68.00
RCD Display Mechatromotive
Hi, does anyone have any experience from the Mechatromotive RCD dashboard http://mechatromotive.com/en/termekek/rcd-display/ links with ECUmaster classic or DTA? I'm trying to connect the wiring according to the instructions but no communication with the ECU.
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: RCD Display Mechatromotive
You need to turn on the generic CAN stream in the ECU.
-
- Posts: 16
- Joined: Thu Mar 16, 2017 5:37 am
- ECU Model: S60 Pro
- Distributor: DTAfast
- Firmware Version: 68.00
Re: RCD Display Mechatromotive
I connected this via RS232 (Tx ecu - Rx Dashboard) that's wrong? Does it only have to be through CAN?
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: RCD Display Mechatromotive
I didn't test the Rs232 output, only the CAN output, which worked fine.
You'll need to check with them if the RS232 connector can be used for data.
If it can, you'll still need to set up the header bytes in the ECU to match what the dash requires.
You'll need to check with them if the RS232 connector can be used for data.
If it can, you'll still need to set up the header bytes in the ECU to match what the dash requires.
-
- Posts: 16
- Joined: Thu Mar 16, 2017 5:37 am
- ECU Model: S60 Pro
- Distributor: DTAfast
- Firmware Version: 68.00
Re: RCD Display Mechatromotive
I have DTA attached to AUTODIGI by PHILTRONICS LTD, it works well.