Page 1 of 1

RCD Display Mechatromotive

Posted: Mon Feb 26, 2018 11:40 am
by f.slabsi
Hi, does anyone have any experience from the Mechatromotive RCD dashboard http://mechatromotive.com/en/termekek/rcd-display/ links with ECUmaster classic or DTA? I'm trying to connect the wiring according to the instructions but no communication with the ECU.

Re: RCD Display Mechatromotive

Posted: Mon Feb 26, 2018 11:49 am
by Alex DTA
You need to turn on the generic CAN stream in the ECU.

Re: RCD Display Mechatromotive

Posted: Mon Feb 26, 2018 12:22 pm
by f.slabsi
I connected this via RS232 (Tx ecu - Rx Dashboard) that's wrong? Does it only have to be through CAN?

Re: RCD Display Mechatromotive

Posted: Mon Feb 26, 2018 3:12 pm
by Alex DTA
I didn't test the Rs232 output, only the CAN output, which worked fine.
You'll need to check with them if the RS232 connector can be used for data.
If it can, you'll still need to set up the header bytes in the ECU to match what the dash requires.

Re: RCD Display Mechatromotive

Posted: Tue Feb 27, 2018 1:17 am
by f.slabsi
I have DTA attached to AUTODIGI by PHILTRONICS LTD, it works well.