Page 1 of 2
Fails to unlock map in dtaswin.
Posted: Tue Jun 26, 2018 12:00 pm
by engen
Hi
After I changed the serie data output settings acording to the getting started guide on dtadroid.com I cant unlock the map on dtaswin.
When i type inn my pin code and try to unlock the map I get the message "failed to unlock map. Try again."
When i cross it out i get a error message saying the ecu is not responding, please try again.
Re: Fails to unlock map in dtaswin.
Posted: Tue Jun 26, 2018 2:31 pm
by Alex DTA
You have a USB driver issue most likely.
Download the correct version from the website, then follow the update guide also from the website.
Re: Fails to unlock map in dtaswin.
Posted: Tue Jun 26, 2018 5:31 pm
by engen
Im not using a usb port. I use a laptop with a rs232 connector.
And even i get the message that the ecu is not responding I get the realtime info on rpm tps water temp etc.
Re: Fails to unlock map in dtaswin.
Posted: Wed Jun 27, 2018 3:16 am
by Antral
Check that you don't have a bent pin in the 15 pin connector.
Re: Fails to unlock map in dtaswin.
Posted: Wed Jun 27, 2018 4:56 am
by engen
All the pins are fine.
This problem came immediately after I changed the settings to use dta droid. Also if I type in the wrong pin code it says I have the wrong pin code. But with the right one it fails to unlock.
Re: Fails to unlock map in dtaswin.
Posted: Wed Jun 27, 2018 11:46 am
by Alex DTA
What version of the software are you using?
Re: Fails to unlock map in dtaswin.
Posted: Wed Jun 27, 2018 11:59 am
by engen
Im using the newest. V85.30.
Re: Fails to unlock map in dtaswin.
Posted: Wed Jun 27, 2018 2:13 pm
by Alex DTA
Try 82.16:
http://www.dtafast.co.uk/download_files ... Series.zip
Looks like you've found a bug in the new software.
Re: Fails to unlock map in dtaswin.
Posted: Thu Jun 28, 2018 3:34 pm
by engen
Ok I will test that tomorrow.
Re: Fails to unlock map in dtaswin.
Posted: Fri Jun 29, 2018 3:31 pm
by engen
With the 82.16 software I first get the message. "Map not transferred successfully, Please try again" when i press try again a couple pf times i get the message "Ecu not responding, please try again"
I still get the info on rpm and water temp tps etc.