Hello!
We wanted to use our s100 pro can datastream in our dynamometer program, and found a bug with the spark advance packet.
If the knob function activated, the can stream advance value start to jump between the modified advance and the advance w/o knob trim. If I swith off the knob trim function, then dta send good values. If I reset the ecu with knob on, then ecu send good values to approx. one minute, then start jump between the two value.
Here is a video from the situation:
http://cosworth.hu/misc/can_screencast.webm
The dtaswin real time data on the left side, the can stream incoming to dynamax data acquisition software on the right side.
knob on: jumping can stream spark advance
knob off at 33sec: steady values
knob on again at 44sec: jumping again
reset ecu with knob on at 50sec: error disappear
after 1min at 1m54sec: the error start again
Please help
Zoltan
CAN stream advance packet bug
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: CAN stream advance packet bug
Hi Zoltan
Please can you email the us at office@dtafast.co.uk? We will need to set up some logging to investigate this further.
Kind regards
Alex
Please can you email the us at office@dtafast.co.uk? We will need to set up some logging to investigate this further.
Kind regards
Alex
Re: CAN stream advance packet bug
Thanks, I have emailed it now.Alex DTA wrote:Hi Zoltan
Please can you email the us at office@dtafast.co.uk? We will need to set up some logging to investigate this further.
Kind regards
Alex