finding pins for an o.e peugeot/citroen connector?

Wiring best practices and loom building technique
Post Reply
welshpug
Posts: 130
Joined: Tue Sep 06, 2011 4:53 am
ECU Model: S40 Pro

finding pins for an o.e peugeot/citroen connector?

Post by welshpug »

looking to source some pins for a round multiplug to build a new loom for my Citroen ZX, to save making 13 solder joints to old wire!

not sure who makes the housings but here's a picture of the pin concerned (click for a larger image...)


Image

Have had a look at VWP Polevolt and Simtek without any luck, any other suggestions?


here's a borrowed image of the connector type

Image
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: finding pins for an o.e peugeot/citroen connector?

Post by stevieturbo »

Looks very similar to Econoseal, but you'd need to buy one to check

http://www.polevolt.co.uk/acatalog/Term ... sings.html

Or possibly some of the Sumitomo

http://www.polevolt.co.uk/acatalog/Sumi ... inals.html
welshpug
Posts: 130
Joined: Tue Sep 06, 2011 4:53 am
ECU Model: S40 Pro

Re: finding pins for an o.e peugeot/citroen connector?

Post by welshpug »

thanks, they look similar, but these plugs dont have male/female pins, both plugs use the same type.

I found the part numbers and prices on Servicebox Peugeot, theyre about 40p each, no guarantees they'll sell me any though but worth a try!
User avatar
mefmotorsport
Posts: 543
Joined: Mon Aug 01, 2011 6:45 am
ECU Model: S100 Pro
Distributor: Mefmotorsport
Firmware Version: 79
Location: Merseyside
Contact:

Re: finding pins for an o.e peugeot/citroen connector?

Post by mefmotorsport »

I think I'd rather make 13 solder joints and heatshrink rather than use a French connector!

Martin
welshpug
Posts: 130
Joined: Tue Sep 06, 2011 4:53 am
ECU Model: S40 Pro

Re: finding pins for an o.e peugeot/citroen connector?

Post by welshpug »

I need to use the connector regardless Martin :lol: its where the engine loom connects to the car loom :)
Post Reply