The manual says this:-
But that's in ECU firing order rather than cylinder number?The Manual wrote: Non Sequential
Use O/P’s 1,2,3 etc, up to the number of cylinders to any injector
As sequential, I wired them like this:
Injector driver 1 - Cyl 1
Injector driver 2 - Cyl 5
Injector driver 3 - Cyl 3
Injector driver 4 - Cyl 6
Injector driver 5 - Cyl 2
Injector driver 6 - Cyl 4
What changes do I need to make to run the injectors as grouped?
It's a bit confusing because the "only Seq above rpm" feature implies it can run as grouped until it sees a cam signal, but if I turn off sequential and stick some more fuel in the base map to get the AF right again, it runs very rough.