Page 1 of 1

S60 into toyota Gt4 ST185

Posted: Wed Jun 21, 2017 7:30 am
by 1127r
Hi its a bit of a long shot but does anyone know the pinouts on a Toyota GT4 ST185 Ecu socket/plug i am considering making a plug in loom to my Dta S60 i am sure it must have been done before any advice would be appreciated
Thanks Andy

Re: S60 into toyota Gt4 ST185

Posted: Wed Jun 21, 2017 1:08 pm
by stevieturbo

Re: S60 into toyota Gt4 ST185

Posted: Thu Jun 22, 2017 8:50 am
by 1127r
Thanks Stevieturbo

Re: S60 into toyota Gt4 ST185

Posted: Thu Jun 22, 2017 12:58 pm
by stevieturbo
Although sometimes it can be just as handy to build a new engine loom, sometimes OEM do things that dont marry up well with a plug n play type setup. Although it is a method I like using, as it means nothing is so permanent.

So plan it all very carefully and dont be afraid to make a partial new loom if it doesnt look like the OEM patch might work properly.

Re: S60 into toyota Gt4 ST185

Posted: Fri Jun 23, 2017 5:43 pm
by ignitionautosport
I sometimes do that, with MAP/IAT/boost sol. in a separate little harness.

Re: S60 into toyota Gt4 ST185

Posted: Mon Jun 26, 2017 3:39 pm
by 1127r
Thanks guys yes I have already realised it may pay to forget the idea of trying to make a plug n play loom and start afresh as I think it would be sensible to change the throttle body and sensor setup and rotor pickup system.

Re: S60 into toyota Gt4 ST185

Posted: Mon Jun 26, 2017 6:28 pm
by stevieturbo
You can still pnp for some of the stuff, eg power, injectors, rev counter, some sensors etc.

But it might be convenient to add things like crank/cam sensor, coil triggers etc on a new section of loom, assuming you werent going to retain the dizzy thing they used to use.

But there is still a lot of the OEM wiring you can make use of and plug into so should you ever need to fallback to the original ecu, it will be easy to do.

Re: S60 into toyota Gt4 ST185

Posted: Sun Jul 09, 2017 3:50 pm
by 1127r
Hi again Stevie yes I think your right I think I will need to use a 36-1 crank trigger for accuracy aswell
Andy

Re: S60 into toyota Gt4 ST185

Posted: Wed Jul 12, 2017 1:53 am
by swsupermoto
1127r wrote:Hi again Stevie yes I think your right I think I will need to use a 36-1 crank trigger for accuracy aswell
Andy
use a beams trigger wheel