Hi, me again with another pointless question
I want to be able to convert my ABS signal so I can do the undriven wheel speed and finally get TC working. I'm going to use the JBPerf board to do the converting, but with regards to using the shielded cable, is twisted pair acceptable, or would I be better off using a cable that has the separate wire sheath around it?
Thanks
Shielded Cable
- ignitionautosport
- Posts: 577
- Joined: Wed Jul 27, 2011 5:30 am
- ECU Model: S80 Pro
- Location: New Zealand
- Contact:
Re: Shielded Cable
I personally prefer shielded sheath type, but a lot of ABS systems wiring is simple twisted pair.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
-
- Posts: 3587
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Shielded Cable
Mag sensors should be shielded.
Hall sensors it isnt important
Hall sensors it isnt important
Re: Shielded Cable
Thanks you chaps