S100 ECU to CAN Adapter Interface cable

Wiring best practices and loom building technique
Post Reply
V10Star
Posts: 2
Joined: Thu Jul 19, 2012 5:55 pm
ECU Model: S100 Pro
Firmware Version: 63
Location: Northern California

S100 ECU to CAN Adapter Interface cable

Post by V10Star »

We recently acquired a motor equipped with a S100 ECU and a sysWORXX CAN adapter. However we were not supplied the interface cable between the two units. I have found the pin outs for the sysWORXX CAN adapter, but have been unable to find the pin outs for the 15pin DSUB on the ECU. Does anyone have these available?
lumley32
Posts: 214
Joined: Mon May 10, 2010 5:09 pm
ECU Model: S80 Pro
Firmware Version: 61

Re: S100 ECU to CAN Adapter Interface cable

Post by lumley32 »

the can-bus is only connected on the sensor connector, pin 26 is + and 28 is - if i recall correctly!
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: S100 ECU to CAN Adapter Interface cable

Post by stevieturbo »

There is a text description of cable pinouts on the wiring diagrams.

Or fortunately this website is still up and running for a good description

http://quantums.info/injection.htm#cables
User avatar
ignitionautosport
Posts: 577
Joined: Wed Jul 27, 2011 5:30 am
ECU Model: S80 Pro
Location: New Zealand
Contact:

Re: S100 ECU to CAN Adapter Interface cable

Post by ignitionautosport »

The CAN connection is in the main connectors as lumley32 stated, check the wiring diagram to confirm pins. I just run the 2 wires to a 2way connector and have the mating connector on the CAN interface wiring.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
V10Star
Posts: 2
Joined: Thu Jul 19, 2012 5:55 pm
ECU Model: S100 Pro
Firmware Version: 63
Location: Northern California

Re: S100 ECU to CAN Adapter Interface cable

Post by V10Star »

Thanks, made my cable and was able connect to my S100.
Post Reply