Hi, I am new to using an ECU and I'm having some trouble getting my engine (Honda CBR600) to start since my coils are not sparking. I have tested the coils using the test functions provided but yet when I try cranking the engine there aren't any sparks.
I currently only have the started motor and coils connected up in attempt to debug the problem but I'm not getting anywhere. Is there something obvious Im missing in the main ignition map? (Assume basic errors apply like I said I am new to ECU)
Thanks
Coils not sparking
Re: Coils not sparking
Assume you have the crank pick-up and (cam sync if fitted and programmed in the set up) wired up as well? Have you replicated the CBR crank wheel / tooth count or gone different? Need more info to have a diagnosis stab!
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: Coils not sparking
rpm reading ? oscilliscope ? diagnostic screen ? errors etc ?
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Coils not sparking
For the ECU to sync, it only needs the crank and cam signals to match what's been entered in to the map.
Start by posting a copy of your map, and a crank trace.
Start by posting a copy of your map, and a crank trace.
Re: Coils not sparking
Sorry all haven't been on here for a while, I have now got it working it was my gap tooth factor that played around with it for a bit so that the ecu was reading the right signal
Thanks
Thanks
Re: Coils not sparking
Sorry all haven't been on here for a while, I have now got it working it was my gap tooth factor that played around with it for a bit so that the ecu was reading the right signal
Thanks
Thanks
- ignitionautosport
- Posts: 577
- Joined: Wed Jul 27, 2011 5:30 am
- ECU Model: S80 Pro
- Location: New Zealand
- Contact:
Re: Coils not sparking
Awesome, and thanks for reporting back
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |