Hi,
I am running an S40 that came with a Watsons kit to convert my Mini to Honda power, but the base map makes it hard to start and it runs fairly rough low down. Does anybody have a map that would help? I'm using a supplied Motorcraft powerpack instead of a dizzy but otherwise standard motor. And MAP not connected as yet, so only TPS, but I will connect same if a good supplied map uses it.
Failing which, does anybody know of a dyno in Perth, Western Australia, where the operator has ever worked with a DTA? I'm reluctant to spend a couple of grand waiting for the dyno man to come up to speed.
Thanks.
B16A2 map needed
- ignitionautosport
- Posts: 577
- Joined: Wed Jul 27, 2011 5:30 am
- ECU Model: S80 Pro
- Location: New Zealand
- Contact:
Re: B16A2 map needed
I know of a guy in Aus though east side I think, I'll point him here though in case.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
-
- Posts: 82
- Joined: Fri May 30, 2014 7:36 am
- ECU Model: S60 Pro
- Distributor: mosley rolling road
- Firmware Version: 66
Re: B16A2 map needed
I'm also looking for a map for this.
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: B16A2 map needed
As always, work through the manual and build your own calibration.
You need to check all settings anyway.
Largely the only slightly awkward bit might be crank trigger setup ( what are you using ? )
And ignition coil setup....again, what are you using ?
Some Honda's use an inverted coil charge not too unlike "external coil amps", but not sure if it's the same.
So OEM coil may not be compatible.
You need to check all settings anyway.
Largely the only slightly awkward bit might be crank trigger setup ( what are you using ? )
And ignition coil setup....again, what are you using ?
Some Honda's use an inverted coil charge not too unlike "external coil amps", but not sure if it's the same.
So OEM coil may not be compatible.
Re: B16A2 map needed
i have different maps for the honda b16a2 engine. NA or turbo
send me an email
turbo6@hotmail.com
if you have a good turbo map, please send it to me !
same email adress
send me an email
turbo6@hotmail.com
if you have a good turbo map, please send it to me !
same email adress
Re: B16A2 map needed
Hello everybody
I'm searching for a Honda b16a2 OEM N/A map for my s60.
I will use some custom sensors to manage the rpm and cam and a custom ignition coil from motorbike.
I only need a map to have fuel and ignition table and make a quick start to control the loom, gearbox ...etc
After that I will bring my car to a professional tunner
So I only need a base map very close to an OEM B16a2 engine
Thanks
I'm searching for a Honda b16a2 OEM N/A map for my s60.
I will use some custom sensors to manage the rpm and cam and a custom ignition coil from motorbike.
I only need a map to have fuel and ignition table and make a quick start to control the loom, gearbox ...etc
After that I will bring my car to a professional tunner
So I only need a base map very close to an OEM B16a2 engine
Thanks