Help needed with real time mapping page

Discuss issues and tuning software like DTASWin, E-Race, MegaLogViewer(DTA), etc. Also post archive versions of firmware.
Post Reply
DiscoPotatoes
Posts: 52
Joined: Fri May 04, 2012 2:51 pm
ECU Model: P8 Pro

Help needed with real time mapping page

Post by DiscoPotatoes »

I've lost the fuel and ignition maps, they are ticked in the display options but not on screen, I've uninstalled and reinstalled but to no avail, all the other setting appear if ticked?
I've tried it on another laptop and the ignition is visible but not the fuel.
I thought it could be a display setting on the laptop so looked at that to,
Rob Stevens
Posts: 1247
Joined: Thu Jul 28, 2011 4:10 am
ECU Model: S100 Pro
Distributor: None-Coil On Plug :)

Re: Help needed with real time mapping page

Post by Rob Stevens »

Try loading the display settings again
Alex DTA
Posts: 1622
Joined: Fri Feb 28, 2014 1:03 pm
ECU Model: S40 Pro
Distributor: DTA
Firmware Version: 79

Re: Help needed with real time mapping page

Post by Alex DTA »

Is this DTAWin for an E48/P8?
They're either behind one of the other screens (very small), or they've been dragged to a part of the screen that can't be seen.

I can send over a screen settings in the morning for you.
DiscoPotatoes
Posts: 52
Joined: Fri May 04, 2012 2:51 pm
ECU Model: P8 Pro

Re: Help needed with real time mapping page

Post by DiscoPotatoes »

I think I've sorted it, I found a sample screen display and loaded that, off line so as Long as when I connect to the ecu I can load that sample then I'm good,
Thanks very much for your help
Post Reply