Logging switch problem

This section is dedicated to discussion of DTA engine control units such as the DTA E48 EXP, P8 Pro, DTA S40, S60, S80, and S100, as well as all things ECU related.
Post Reply
maxiice
Posts: 67
Joined: Sat Apr 13, 2013 5:16 pm
ECU Model: S80 Pro
Firmware Version: 63

Logging switch problem

Post by maxiice »

Reading logs is so time consuming so i only want to log when a problem happens

Manual say when wire 1 see 0 volt it starts to log. is this the same as ground?

I have set logging option to log on switch, i have set aux 2 to active

And i am grounding wire 1 via switch, but it logs all the time

what it wrong?

S80 pro
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Logging switch problem

Post by stevieturbo »

What is time consuming about it ? You can close in on any point on a log in seconds.

But you would ground a switch to enable logging, and configure the software so it knows this is the method you wish to use.
maxiice
Posts: 67
Joined: Sat Apr 13, 2013 5:16 pm
ECU Model: S80 Pro
Firmware Version: 63

Re: Logging switch problem

Post by maxiice »

stevieturbo wrote:What is time consuming about it ? You can close in on any point on a log in seconds.

But you would ground a switch to enable logging, and configure the software so it knows this is the method you wish to use.
Thanks :)
Yes thats what i did, but it still logs all the time
Wire 1. is shared with aux2, do i set anyting here or is it just in "logging options"

If i was to work my way thrue 40 min of log, it does take a whild, if you wiew them direqtly from the S80
stevieturbo
Posts: 3577
Joined: Tue Aug 02, 2011 12:08 pm
ECU Model: No ECU
Location: Norn Iron

Re: Logging switch problem

Post by stevieturbo »

Do not view logs directly on the SWin software, download them and view on either ERace or MegaLogViewer.

Pin 1 on the sensor connector is shared with Ana2

You may need to turn off Ana2 functions, and will need to enable logging switch in logging options.
maxiice
Posts: 67
Joined: Sat Apr 13, 2013 5:16 pm
ECU Model: S80 Pro
Firmware Version: 63

Re: Logging switch problem

Post by maxiice »

Ok thanks will do :)
Post Reply