Great feature being able to swing the injection angle from the knobs box when in dyno mode.
However if you are using the 20x14 table for injection angle the feature doesn't work, it looks like it is from the live adjustment screen but it's not doing anything.
Soon as you disable the angle map it works properly again. Not the end of the world but a bit annoying when it looks like its working but the engine doesn't see any change.
SW could perhaps flash up a warning if you try and select left knob for angle with 20x14 active?
Injection angle bug?
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Injection angle bug?
Yup, that's a known bug.
The angle is being altered on the ECU, so you can find the correct point, but it doesn't record it in the software.
I know how to fix it, and will do it in the new software shortly (currently on some firmware updates). then in the old software as well, which will take a bit longer to do.
The angle is being altered on the ECU, so you can find the correct point, but it doesn't record it in the software.
I know how to fix it, and will do it in the new software shortly (currently on some firmware updates). then in the old software as well, which will take a bit longer to do.
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: Injection angle bug?
Alex, no that's not quite correct, if using the 20x14 the ecu does not move the injection point under control of the knob. If the 20x14 is disabled it does work. Agreed that the selected point is not recorded in either case.
-
- Posts: 1622
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: Injection angle bug?
OK, I'll check that.
Either way, I'll fix it in the new software ASAP. I'm aiming to have a decent firmware update in the next couple of weeks.
Either way, I'll fix it in the new software ASAP. I'm aiming to have a decent firmware update in the next couple of weeks.