thats the problem, i have not changed anything and i still have the same map
i had this problem also with old firmware i update to the last one and that was the first time that map2 works and i was so happy
but now still does not activate...
S60 2nd map option
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: S60 2nd map option
Email or upload a copy of the map so I can look at it when I'm back in thevoffice
Re: S60 2nd map option
lets takes things from the begging, past 5 days the cooling fun stop working but it was working from the external switch but not from s60 signal, also measure it with volt meter i had 11.47 volt using the activation switch and 0 when s60 give the signal at 88 degrees...
i believe that from this point map2 stop working too but i am not sure
tonight i give it one more chance, map2 works and also the cooling fan without actiavation from external switch
i believe that from this point map2 stop working too but i am not sure
tonight i give it one more chance, map2 works and also the cooling fan without actiavation from external switch
Re: S60 2nd map option
second day, map2 and cooling fan works
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: S60 2nd map option
Send the map to ALEX, looks like the cooling fan and high temp warning (shown in your image) may be holding map 2 off, despite the check box (always switch).
Re: S60 2nd map option
i will...but it think that always says high temp even if i have 30 degree coolant but i will chack it again for sure
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: S60 2nd map option
upper warning level is seto to 110
maximum water temp for als becomes blank when map2 check box is ticked...because is only for als
also i check it a few moments ago i had 60 degree coolant and stil says water temp high, but i beleive that its only when als is active not map2
maximum water temp for als becomes blank when map2 check box is ticked...because is only for als
also i check it a few moments ago i had 60 degree coolant and stil says water temp high, but i beleive that its only when als is active not map2
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: S60 2nd map option
MAP2/ALS are considered as the same thing on DTA.
You may not choose to use the 2nd MAP for ALS, but that was still primarily what Allan expected.
it's a strange way of doing things though.
You may not choose to use the 2nd MAP for ALS, but that was still primarily what Allan expected.
it's a strange way of doing things though.