Thought this may be useful for someone ?
I run Boost-By-Gear with my S80 Pro. I also have 2 steering wheel mounted buttons, one it a latching button that makes/breaks the 12V to the boost solenoid, that in effect give me actuator pressure if it's really wet or BBG when enabled and the ECU is on MAP1.
The other button is a push-to-make and switches to MAP2 which is my instant high boost overtaking map, regardless of gear.
The dyno plots show the effectiveness of BBG
S80Pro and boost by gear success
-
- Posts: 137
- Joined: Tue Jan 16, 2018 9:38 am
- ECU Model: S100 Pro
- Distributor: DTA
- Location: Aberdeen
Re: S80Pro and boost by gear success
Very neat! How did you go about choosing the different levels of boost for each gear?
Re: S80Pro and boost by gear success
Initially I just set each gear to give a few % more duty cycle which gave this boost plot as I went through the gears. Green is MAP
The final tweaking was done on the dyno, but it was minimal.
The final tweaking was done on the dyno, but it was minimal.
-
- Posts: 137
- Joined: Tue Jan 16, 2018 9:38 am
- ECU Model: S100 Pro
- Distributor: DTA
- Location: Aberdeen
Re: S80Pro and boost by gear success
Ah! Sounds a sensible aproach. Good result!