Hello
I would like to know if I can use the data from turbo duty in CAN.
Thanks
DTA S40 CAN turbo duty
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: DTA S40 CAN turbo duty
Explain better what you are trying to do or achieve ?
DTA only sends data via CAN, for say a dash display or similar.
DTA only sends data via CAN, for say a dash display or similar.
-
- Posts: 1623
- Joined: Fri Feb 28, 2014 1:03 pm
- ECU Model: S40 Pro
- Distributor: DTA
- Firmware Version: 79
Re: DTA S40 CAN turbo duty
Turbo Duty Cycle is not sent on the S Series Standard CAN Stream
Re: DTA S40 CAN turbo duty
Hello
I need the turbo duty cycle by CAN to log on the dashboard but is not on the list of data send by CAN
Is possible to add this?
Thanks
I need the turbo duty cycle by CAN to log on the dashboard but is not on the list of data send by CAN
Is possible to add this?
Thanks
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: DTA S40 CAN turbo duty
Does the dash you are using have spare inputs that you can use with some maths calculation to display, if you copy the turbo solenoid PWM signal to the dash?
Re: DTA S40 CAN turbo duty
What is the adress of the turbo solenoid pwm signal?
-
- Posts: 18
- Joined: Sun Jan 23, 2022 6:37 pm
- ECU Model: S60 Pro
- Firmware Version: 78.01
- Location: Paso Robles, California
Re: DTA S40 CAN turbo duty
I believe Rob is suggesting splicing the wiring so it also goes to an available input on your dash.
-
- Posts: 1250
- Joined: Thu Jul 28, 2011 4:10 am
- ECU Model: S100 Pro
- Distributor: None-Coil On Plug :)
Re: DTA S40 CAN turbo duty
David that is exactly what I was suggesting, just not describing it very well