Bosch 4.9 wideband sensor

[Totalnova]

So I have a bosch 4.9 sensor on my AEM gauge with intergrated controller I have it set up with my sS40 ecu but I just want to make sure it's configured correctly, will one of the sensor scales all ready set up work or do I need to manually enter them, if so how do I go about doing this?

Thanks Nick

[Alex DTA]

There's no preset for the AEM gauge.
Just fill in the voltage to lambda/AFR table from the AEM manual.

[Totalnova]

Thanks, I'll have to try and see if I havent thrown it away, if not I'm sure there will be a pdf online somewhere.

[David Ferguson]

This should be the PDF... https://www.aemelectronics.com/sites/de ... _Gauge.pdf

Note there are various voltage output modes available. See Page 11