DTAForum.com - a forum for the DTA ECU

I think it's a miracle but it's started, I've cut 2 teeth off the crank wheel turned all the sequential bits off, altered the general settings and it's going.

Now I can sleep!

Thanks all for your help.

12-2 that was brave! I'd have done 12-1 to start with Well done. You will have to try and balance the trigger up by drilling some holes if you can.

And make sure to check ignition timing with a timing light.

If you are not checking at 0 deg, make sure you check it at at least two distinctly different timing numbers and at a couple of different rpm's to make sure it's behaving as you expect it to

Somebody else has done the same. I just copied him.

I've got a few spare crank wheels so I'll see how it goes, at least I know it starts now.

I didn't want to waste any time and money on a rolling road chasing a wire I'd put in the wrong place!

Congrats. Feels good when you get it going.

Now it's going and I've fiddled around with things I'm starting to understand it all better.

There's a lot to learn though.

Thanks again for the help