DTAForum.com - a forum for the DTA ECU

I have problems with dtas-60, it turned off and it does not turn on, i testing the injectors and coils , the oscilloscope everything works ok, but when turning on nothing, I have loaded several maps that I have and it does not turn on so, I discard settings, the sensors all well and if the actuators operate injectors and coils because when turning on it does not go, the control unit would be damaged?
Thanks.

there seems to be a language barrier here.

If you have access to read sensors, oscilloscope etc...then clearly the ecu IS turned on and alive.

So is the problem the engine does not run, or something else ?

Did something occur that leads you to think something may be damaged ?

Has this ever run correctly ?

Please post an image of the crankshaft oscilloscope.
If you can do a crank oscilloscope, you can also see the Diagnostics Display.
When you crank the engine, does the Diagnostic Display show the ECU synchronising?

I am Spanish and I use a translator, sorry.
the car has been working for 2 years, the other day it went off in the race and it does not turn on, the oscilloscope is ok, when testing injectors and coils, it works but when trying to start it does not work.
tomorrow I will send image

So the ecu is ON and working as normal ?

but the engine will not run ?

Ok
Te ecu is running but the engine not run

'When you crank the engine, does the Diagnostic Display show the ECU synchronising?'

Make a video of the computer screen as you are trying to start the engine with either real time display but also with diagnostic display as Rob and Alex have asked above.

Saturday I look at it in the vehicle but the ecu is ok, we have tested it in another car and it works, we will test sensors and installation, thanks I will inform you

basics...fuel, air, spark.