DTAForum.com - a forum for the DTA ECU

the car does not turn on, I do not have injectors and coil, I put an oscilloscope, but it does not start
first:


after reviewing. but it does not start


tomorrow I will change the cables for others with better shielding,
and I'll try

You have a cam sensor issue. That should run fine with sequential/cams turned off.

Exactly what is it using for a cam sensor ?

Normal cosworth "Phase" sensor was inside the distributor, and had 2 teeth. This would not be usable without a little modification.

Post up the map. It may be that the sequential or other settings have been changed somehow.
When you say the ecu is ok on another engine, is it exactly the same engine and sensors or did you change the map?

I test on another engine by changing the map

the car does not start with the cartography that it had previously, and it takes 1 year with her, it had another cartography made with a bigger bridle and it did not start either.
I put a standard and if you turn on, very weird. I modified something in my cartography and now it starts but it shuts down and it has a lot of gas ....... Sensors are ok.
very strange, and if I have handled the programming I had before does nothing ...

failure map sensor,