S100 ECU to CAN Adapter Interface cable
-
- Posts: 2
- Joined: Thu Jul 19, 2012 5:55 pm
- ECU Model: S100 Pro
- Firmware Version: 63
- Location: Northern California
S100 ECU to CAN Adapter Interface cable
We recently acquired a motor equipped with a S100 ECU and a sysWORXX CAN adapter. However we were not supplied the interface cable between the two units. I have found the pin outs for the sysWORXX CAN adapter, but have been unable to find the pin outs for the 15pin DSUB on the ECU. Does anyone have these available?
Re: S100 ECU to CAN Adapter Interface cable
the can-bus is only connected on the sensor connector, pin 26 is + and 28 is - if i recall correctly!
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: S100 ECU to CAN Adapter Interface cable
There is a text description of cable pinouts on the wiring diagrams.
Or fortunately this website is still up and running for a good description
http://quantums.info/injection.htm#cables
Or fortunately this website is still up and running for a good description
http://quantums.info/injection.htm#cables
- ignitionautosport
- Posts: 577
- Joined: Wed Jul 27, 2011 5:30 am
- ECU Model: S80 Pro
- Location: New Zealand
- Contact:
Re: S100 ECU to CAN Adapter Interface cable
The CAN connection is in the main connectors as lumley32 stated, check the wiring diagram to confirm pins. I just run the 2 wires to a 2way connector and have the mating connector on the CAN interface wiring.
| '94 GSR Lancer | '96 Toyota Carib 20V | '83 Toyota Starlet | www.ignitionautosport.co.nz |
-
- Posts: 2
- Joined: Thu Jul 19, 2012 5:55 pm
- ECU Model: S100 Pro
- Firmware Version: 63
- Location: Northern California
Re: S100 ECU to CAN Adapter Interface cable
Thanks, made my cable and was able connect to my S100.