Page 1 of 1
S100 ECU to CAN Adapter Interface cable
Posted: Thu Jul 19, 2012 6:09 pm
by V10Star
We recently acquired a motor equipped with a S100 ECU and a sysWORXX CAN adapter. However we were not supplied the interface cable between the two units. I have found the pin outs for the sysWORXX CAN adapter, but have been unable to find the pin outs for the 15pin DSUB on the ECU. Does anyone have these available?
Re: S100 ECU to CAN Adapter Interface cable
Posted: Fri Jul 20, 2012 3:43 am
by lumley32
the can-bus is only connected on the sensor connector, pin 26 is + and 28 is - if i recall correctly!
Re: S100 ECU to CAN Adapter Interface cable
Posted: Fri Jul 20, 2012 6:39 am
by stevieturbo
There is a text description of cable pinouts on the wiring diagrams.
Or fortunately this website is still up and running for a good description
http://quantums.info/injection.htm#cables
Re: S100 ECU to CAN Adapter Interface cable
Posted: Fri Jul 20, 2012 7:07 am
by ignitionautosport
The CAN connection is in the main connectors as lumley32 stated, check the wiring diagram to confirm pins. I just run the 2 wires to a 2way connector and have the mating connector on the CAN interface wiring.
Re: S100 ECU to CAN Adapter Interface cable
Posted: Fri Jul 20, 2012 1:25 pm
by V10Star
Thanks, made my cable and was able connect to my S100.