DTAForum.com - a forum for the DTA ECU

How much these cost and is there high quality pictures of the latest modell somewhere ?

When the bigger screen modells are ready?

I found a couple of picture's of this display.

so ive finally got my engine running and kind of have the display mounted.
ecu is detected but no data stream.

found a tick box in the software for data stream.

do i need to add anything in the rest of the boxes to get this working properly?
number of header bytes etc?

cheers
Drew

im obviosly missing something, tick box checked, still nothing.

Drew

Roverdose wrote:im obviosly missing something, tick box checked, still nothing.

Drew

Hey Drew,
I just plugged mine in a few weeks ago, haven't had anytime to mess with it...
Did you get this opening screen when it powered-up?

Simon

simmilar but not the same, ill go take a pic.

btw it recognises the ecu type and the map i have in there, just no stream.

Drew

on ignition i get this...



doesnt chage with the engine running, change the mode, no difference.

searched the net, setting up an aim display says you need
2 (in header bytes)
208
208 (in the next 2 boxes)

will try that in a mo.

cheers
Drew

Roverdose wrote:found a tick box in the software for data stream.

do i need to add anything in the rest of the boxes to get this working properly?
number of header bytes etc?

cheers
Drew

Actually, yes, for serial stream you need the following;
Number of header bytes: 4
Header bytes values: 170-85-1-254-0-etc.

But I see that you still have the old firmware, for the advanced stream(old dyno stream), you’ll need to upgrade to the newer firmware(to make it work with the later DTA firmware), I’ll send you a few files with the newer firmware and how to upgrade.

thank you Marco.

im on v58 atm, might upgrade that later.

cheers
Drew

Then you'll need the update.

I've send you the files.