DTAForum.com - a forum for the DTA ECU

Hi - did a search without a clear answer so here goes.... I'm using a std Ford Mondeo coil pack, crank and cam sensors (the later for sequential fueling and eventually COP's) but I need to know how the 3 pins are positioned - I guess the centre is 12v but which side is 1/4 & 2/3. I have the std mondeo plug so even wire colours would be useful. Then the other two, looking at the sensor plug how are signal & ground arranged ?

I know I can wire then swop around but would like to avoid the faffing around whilst curing all the other inevitable problems!

Cant help, but there is no guarantee the centre is 12v either.

Maybe try measuring resistance across them ?

I'd think if you measured between the two firing pairs...you shouldnt get a reading ?

But between 12v and a firing coil, you would get a reading through the windings ?

I've just checked a mondao coil I have and the center one is 12v, the left is the left pair or coils when viewed from the connector and right right pair.

Thanks Rob - that pretty much the way I was leaning!