Anyone here used their DTA rev count output to a Stack ST700 dash?
Customer pug 205 rally car, has one, just wired S60 into it, all fired up first time, but revs double on stack dash to reality.
I've looked at Stack manual and it just says connect to ES input, but I can see no configuration optiions for it.
Cars running Sagem/Valeo coil, wasted spark etc
thx
DTA rev output to Stack ST700
-
- Posts: 85
- Joined: Fri Dec 30, 2011 10:43 am
- ECU Model: S60 Pro
-
- Posts: 3588
- Joined: Tue Aug 02, 2011 12:08 pm
- ECU Model: No ECU
- Location: Norn Iron
Re: DTA rev output to Stack ST700
Just change tacho pulse output in general engine settings ?
or is it at the lowest value already ?
or is it at the lowest value already ?
-
- Posts: 85
- Joined: Fri Dec 30, 2011 10:43 am
- ECU Model: S60 Pro
Re: DTA rev output to Stack ST700
it was on lowest..stevieturbo wrote:Just change tacho pulse output in general engine settings ?
or is it at the lowest value already ?
found it now.. where were we before tinternet eh - lol
it was the dash setting, previously on 2 cyl as its old ecu was a Euro1 unit which drove it via one side of the coilpack. set dash to 4cyl all good.. once plugged in its setting buttons into the right sockets..
Fired up first time.
woohoo.
thanks steve